Jump to content


Photo

PCC Trigger Install


  • Please log in to reply
4 replies to this topic

#1 PeteMcGuire1881

PeteMcGuire1881

    .380

  • Members
  • PipPip
  • 163 posts
104
  • LocationIndiana

Posted 06 February 2017 - 12:23 PM

So I installed the Rise Armament trigger in my PCC lower with the KNS anti-roll pins and I have a gap (see picture). Everything seems to be seated properly and the screws are tight. Is this normal?6058dec489389fbddb14ae6d24ca0bd6.jpg


Sent from my iPhone using Tapatalk

#2 Matt Rigsby

Matt Rigsby

    Cyrwus Jr.

  • Members
  • PipPipPipPipPipPip
  • 9,300 posts
3,682
  • LocationOklahoma City

Posted 06 February 2017 - 12:57 PM

It's the same with the 3 sets of KNS pins I have.

IDGAF CASH ME OUSSIDE HOW BOW DAT!


#3 PeteMcGuire1881

PeteMcGuire1881

    .380

  • Members
  • PipPip
  • 163 posts
104
  • LocationIndiana

Posted 06 February 2017 - 12:59 PM

All I needed to hear. Thanks!


Sent from my iPhone using Tapatalk

#4 Wall

Wall

    El Diablo

  • Administrators
  • 12,937 posts
3,801
  • LocationNW OKC

Posted 06 February 2017 - 01:48 PM

Yeah, I've not seen any pin sets that don't have a little space. Same for the ambi safety levers. Most likely to allow for thicker than mil spec receivers.

#5 59nolimit

59nolimit

    9 mm

  • Members
  • PipPipPip
  • 377 posts
96
  • LocationGarden City, KS

Posted 07 February 2017 - 07:58 AM

I have 2 of them in ar15 rifles. They don't have that much gap but they do have a little.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users